Programming Homelink To A Miscellaneous Device; Reprogramming A Single Homelink Button - Dodge DURANGO 2019 User Manual

2. Push the programmed HomeLink button to
confirm that the garage door opener motor
operates. If the garage door opener motor
does not operate, repeat the steps from the
beginning.
WARNING!
• Your motorized door or gate will open and
close while you are programming the uni-
versal transceiver. Do not program the
transceiver if people or pets are in the
path of the door or gate.
• Do not run your vehicle in a closed garage
or confined area while programming the
transceiver. Exhaust gas from your ve-
hicle contains Carbon Monoxide (CO)
which is odorless and colorless. Carbon
Monoxide is poisonous when inhaled and
can cause you and others to be severely
injured or killed.
60
Programming HomeLink To A
Miscellaneous Device
Refer to "Programming HomeLink To A Garage
Door Opener" for the procedure on how to pro-
gram HomeLink to a miscellaneous device, as it
follows the same procedure. Be sure to deter-
mine if the device has a rolling code, or non-
rolling code before beginning the programming
process.
NOTE:
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink to pick up the signal
during programming. Similar to this Canadian
law, some U.S. gate operators are designed to
time-out in the same manner. The procedure
may need to be preformed multiple times to
successfully pair the device to your HomeLink
buttons.

Reprogramming A Single HomeLink Button

To reprogram a single HomeLink button that has
been previously trained, without erasing all the
channels, follow the procedure below. Be sure
to determine whether the new device you want
to program the HomeLink button to has a Roll-
ing Code, or Non-rolling Code.
1. Cycle the ignition to the ON/RUN position,
without starting the engine.
2. Push and hold the desired HomeLink button
until the HomeLink Indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button, proceed with
Step 2 in "Programming HomeLink To A
Garage Door Opener" and follow all remain-
ing steps.