Completing The Installation - Symantec GHOST 14 Manual

24 Installing Norton Ghost
Installing Norton Ghost

Completing the installation

8 Click Finish to complete the installation.
9
Remove the product CD from the media drive, and then click Yes to exit the
installation wizard and restart the computer.
If you click No because you plan to restart your computer yourself at a later
time, note that you cannot run Norton Ghost until after you restart your
computer.
After you install the product, you are prompted to license or activate your product.
You can then run LiveUpdate to check for product updates, and then configure
your first backup.
Note: If this product came pre-installed from a computer manufacturer, your trial
period could be as long as 90 days. Refer to the Activate later label.
To complete the installation
1
In the Welcome panel, click Next.
If the product was installed by your computer manufacturer, the Welcome
page might appear the first time that you run Norton Ghost.
2
Do one of the following:
Click I've already purchased the product and have a product key.
Note: You can find the product key on the back of your product CD jacket.
Do not lose the product key. You must use it when you install Norton
Ghost.
Click Activate later to delay the activation of your license. After the trial
period ends, the product will no longer work.
If this product is a trial version of Norton Ghost and you want to purchase
a product key, click Symantec Global Store to connect to the Symantec
Web site.
3
Click Next.
4
Click Run LiveUpdate to check for any product updates since the product
shipped.
5 Click Launch Easy Setup to open the Easy Setup box when you complete the
install process.