Update Dash Configuration Settings Task - Symantec ALTIRIS OUT OF BAND MANAGEMENT COMPONENT 7.0 SP3 - V1.0 Manual

Update DASH Configuration Settings task

Options on the Update ASF Configuration Settings task page
Table 2-25
(continued)
Option
Modify remote control settings
ASF Reset
ASF Power down
ASF Power up
ASF Power cycle
Refresh inventory on settings
change
This task lets you enable DASH and configure DASH settings remotely on client
computers.
Note: The Out of Band Task Agent must be installed on the client computers
before you run the task. The client computer must be turned on to run this task.
The operating system must be running.
For more information, see the Out of Band Management Component Implementation
Guide.
Options on the Update DASH Configuration Settings task page
Table 2-26
Option
Enable DASH
Modify Web Services-based settings
About Out of Band Management Component pages
Update DASH Configuration Settings task
Description
Check to modify the settings in this group when the
task runs.
You can enable Operator, or Administrator rights, or
both.
Check to enable a low latency reset of the system.
Check to enable unconditional power-down (occurs
without any blocking from software or system).
Check to ensure that the sleeping system can be
remotely turned on.
Check to enable a hard reset of the system. This reset
is functionally equivalent to an unconditional
power-down operation, followed by a power-up.
Check if you want the configuration inventory to be
sent to Notification Server after this task runs on the
client computer.
Description
Check to enable DASH.
Check to modify the settings in this group when
the task runs.
59