Changing The Engine Oil - Dixon ZTR ZTR 2301 Operator's Manual

CARE AND MAINTENANCE
CAUTION

CHANGING THE ENGINE OIL:

1. The "snap lock" oil drain valve is located on the left side of the engine crankcase.
2. Place a suitable container under the drain valve. The fitting of a short piece of hose
to the valve will help direct the oil.
3. Push the valve body in and twist to clear the detent notch.
4. Pulling the valve body outward will start the flow of oil.
NOTE:
OIL FILL:
1. Push the valve body in and twist into the detent notch.
2. Clean any spilled oil from engine and chassis.
3. Refill engine with type, and quantity of oil recommended by the engine
manufacturer in engine literature.
PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS.
Page 34
HOT oil may cause burns.
Allow engine to cool before draining oil.
Refer to engine manufacturer's recommendations for frequency of oil
changes.
Closed
PROTECT YOUR ENVIRONMENT
Open