Specifications - Dixon ZTR ZTR 2301 Operator's Manual

CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:

SPECIFICATIONS

Model ZTR 2301
Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
All body parts are made of rotational molded polyethylene. Front body
contains access panel for battery service. Seat tilts forward to allow
transmission service.
11 GA stamped steel construction.
Single 30" cut blade.
Cut height approximately 1" to 4" via 7 position lift handle.
Mechanical; hand lever engagement.
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
16 HP Kohler Command 16, 4-Cycle, Single Cylinder, Overhead Valve, Air-
Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,
Aluminum Head and Block with Cast-Iron Cylinder Liner. Smart Spark
Ignition.
Electric by key switch operation with safety interlocks on parking brake and
blade drive.
Front 11 X 4.00-5 ribbed tread.
Rear 16 X 6.50 X 8 Multi-Trac.
Front 16-21 PSI.
Rear 8-14 PSI.
Fuel 2.0 gallons total.
Engine 1.25 quarts oil.
Width 32.5" outside rear wheel measurement.
Height 32.0" to top edge of seat.
Length 65.5" hitch tab to front bumper.
Weight 440 lbs.
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
Page 3