Specifications - Dixon ZTR ZTR 2301 Operator's Manual

CHASSIS:
BODY:
MOWER DECKS:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:

SPECIFICATIONS

Model ZTR 3014
Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
36" Deck: 11 GA Laser Cut Fabricated - 36" Cut Width
42" Deck: 13 GA Stamped Steel Construction - 42" Cut Width
Cut height approximately 1" to 4" via 7 position lift handle.
Electric clutch.
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
14.5 HP Briggs & Stratton OHV I/C Quiet, 4-Cycle, Single Cylinder, Air-
Cooled, Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced,
Laminated Shroud.
Electric by key switch operation with safety interlocks on parking brake and
blade drive.
Front 11 X 4.00 -5 ribbed tread.
Rear 18 X 8.50 X 8 Multi Trac tread.
Front 16-21 PSI
Rear 8-10 PSI
Fuel 2.0 gallons total.
Engine 1.25 quarts oil.
Width 43.0" outside rear wheel measurement.
Height 36.0" to top edge of seat.
Length 65.5" hitch tab to front bumper.
Weight 36" Deck: 500 lbs.
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
42" Deck: 520 lbs.
Page 17