Installing An Adapter - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

v The system scans PCI slots 1 and 2 to assign system resources. By default the

Installing an adapter

Complete the following steps to install an adapter:
Attention:
precautions to avoid damage from static electricity. For details on handling these
devices, refer to "Handling electrostatic discharge-sensitive devices" on page 150.
1. Review the safety precautions that are listed in "Related service information"
2. Turn off the server/workstation and peripheral devices and disconnect all
3. Remove the server/workstation from the rack; then, remove the cover as
4. Remove the expansion slot clip that holds the expansion slot cover in place by
50
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
Note: PCI bus A = bus 0; PCI bus B = bus 1.
system starts (boots) devices in the following order: System SCSI devices, then
PCI devices.
Note: To change the boot precedence, start the Configuration/Setup Utility,
select Start Options from the main menu; then, select the PCI SCSI
adapter boot option.
When you handle electrostatic discharge (ESD) sensitive devices, take
on page 147.
external cables and power cords.
shown. For more information see "Removing the cover" on page 48.
Cover release
lever
sliding it upward and off the frame of the server/workstation.
Screws