IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual page 72

4. Remove the expansion-slot cover from PCI slot 2. Store it in a safe place for
5. Remove the adapter from the static-protective package.
6. Install the adapter as follows:
7. Connect the internal cables to the adapter. Note that the 20-pin ribbon cable
64
Hardware Maintenance Manual: xSeries 330 Type 8674, IntelliStation R Pro Type 6851, and Network Equipment Building
System Type 8674
future use.
Attention: Expansion-slot covers must be installed in all vacant slots. This
maintains the electronic emission characteristics of the server and ensures
proper cooling of server components.
Attention: Avoid touching the components and gold-edge connectors on the
adapter.
a. Carefully grasp the adapter by its top edge or upper corners, and align it
with PCI slot 2 on the system board.
Note: You must install the Remote Supervisor Adapter in PCI slot 2.
b. Press the adapter firmly into the PCI slot. Be sure it is firmly seated.
Attention: When you install the adapter in the server, be sure that it is
completely and correctly seated in the system-board connector before you
apply power. Incomplete insertion might cause damage to the system
board or the adapter. Note that power can also be provided to the adapter
through the system management connector (for the location of this
connector, see "Remote Supervisor Adapter components" on page 62).
(see "Inventory checklist" on page 60), which connects the system
management connector on the Remote Supervisor Adapter to the system
board at J57 (see "System board options connectors" on page 44), also supplies
power to the adapter.
Cover release
Screws
lever