Table of Contents
Advertisement
Working with adapters in the R Pro
Your computer comes with two peripheral component interconnect (PCI) adapter
slots on the system board with riser cards installed in them.
Attention:
1. Your computer also comes with an integrated video controller on the system
2. Use only the device drivers supplied on the IntelliStation R Pro Support CD.
The following illustration shows the location of the 33 MHz PCI expansion slots on
the system board.
Note: The illustrations in this document might differ slightly from your hardware.
Adapter considerations
If you ever need to install an adapter, be sure to review the following:
v Locate the documentation that comes with the adapter and follow those
v You can install 32-bit or 64-bit full-length or half-length adapters in the
v Your computer supports 5.0 V and universal PCI adapters; it does not support
v Your computer uses a rotational interrupt technique to configure PCI adapters.
board. However, since the video adapter has already been preinstall in a PCI
slot, the computer BIOS automatically disabled the integrated video controller.
This allows the video adapter in the PCI slot to control the video functions for
your monitor.
instructions in addition to the instructions in this chapter. If you need to change
the switch settings or jumper settings on your adapter, follow the instructions
that come with the adapter.
expansion slots. Full-length adapters are installed in slot 1; half-length adapters
are installed in either slot 1 or 2.
3.3 V only adapters.
Because of this technique, you can install PCI adapters that currently do not
support sharing of PCI interrupts.
PCI slot 2
64 bit
33 MHz (J23)
PCI slot 1
64 bit
33 MHz (J10)
Installing options
53
Advertisement
Table of Contents
