Configuring Your System To Enable Remote Access To The Remote Supervisor Adapter; Configuring The Ethernet Settings - IBM 867413x - Eserver xSeries 330 8674 Hardware Maintenance Manual

Configuring your system to enable remote access to the Remote
Supervisor Adapter
The Remote Supervisor Adapter requires initial configuration to enable remote
access through the Ethernet and serial ports. From Table 10, choose the interface
method by which you want to perform remote management; then, perform the
indicated configuration procedure.
Table 10. Configuration tasks to enable remote access to the Remote Supervisor Adapter
User interface to Remote
Supervisor Adapter
ASM Web interface using
the HTTP protocol
Text-based user interface
using the TELNET protocol
Text-based user interface
using a modem or a null
modem
ASM Web interface using
point-to-point (PPP)
protocol
Text-based user interface
using the TELNET protocol
over PPP
For detailed information about using the ASM Web interface and the text-based
user interface, see the IBM Remote Supervisor Adapter User's Guide for the xSeries 330.

Configuring the Ethernet settings

If you have an accessible, active, and configured dynamic host configuration
protocol (DHCP) server on your network, the hostname, IP address, gateway
address, subnet mask, and DNS server IP address are set automatically. You do not
need to perform further configuration tasks to enable the Ethernet connection
because the default value for the DHCP Setting field is Enabled. If you need to
configure the serial port, go to "Configuring the serial port" on page 73; otherwise,
go to "Completing the installation" on page 76.
If you do not have a DHCP server on your network, complete the following steps
to configure the Ethernet port:
1. If you completed the update firmware procedure and the Utility program
main window is open, go to step 4; otherwise, continue with step 2.
2. Turn on the server.
3. Insert the IBM Remote Supervisor Adapter Support CD into the CD-ROM drive
and close the CD-ROM drive before the server completes POST. The CD starts
automatically and the IBM Remote Supervisor Utility window opens.
Note: If you do not insert the CD and close the CD-ROM drive before POST
completes, you must restart the server with the CD in the CD-ROM
drive.
Connection to Remote
Supervisor Adapter
LAN using the Ethernet port "Configuring the Ethernet
Serial (COM) port
For the configuration
procedure, see:
settings" on page 71
"Configuring the serial port" on
page 73
"Configuring the serial port" on
page 73 and "Setting up
point-to-point protocol" on
page 74
Installing options
71