Dish Network Solo 351 User Manual page 35

Chapter 2
Receiver Description and Installation
Page 30
6. Make sure that the information on the
identifies your system correctly and shows all transponders for all
satellites in your system. Your screen may look different from the
example above depending on the dish antenna system you are using.
7. Select to go to the
OK
8. Select to exit the Point Dish menu. An
Cancel
open asking if the mounting and positioning of your dish is complete
with a indication in the
Locked
select Yes.
If the answer is No, you will need to repoint your dish following the
preceding steps until the mounting and positioning is complete and you
do have the
Locked
9. After you select Yes, the receiver will begin taking a software upgrade.
You will see a Warning that
downloaded into your receiver
the progress of this upgrade.
10. Once the software upgrade is complete, you will see a message that your
receiver's memory is being upgraded.
11. Do not disturb the receiver while the receiver's memory is being
upgraded.
: If you are installing other DISH Pro or DISH Pro Plus receivers,
Note
be sure to run
Check Switch
necessary software upgrade.
12. When the memory upgrade is complete, you should be watching TV.
Your dish antenna installation is now complete.
Installation Summary
screen.
Point Dish/Signal
screen. If the answer is yes,
Point Dish
indication.
Vital program information will now be
. You will also see a status bar showing
on all of them, and allow them to take the
screen
screen will
Attention