Disabling Protocols
Important:
Checking
SSL/TLS Status
To View a Certificate
To Delete a Certificate
Overriding Port Status
AXIS 5550 User's Manual
To further increase security, you must disable protocols that are
considered insecure;
•
FTP (also used by AXIS ThinWizard, if FTP is disabled, AXIS ThinWizard
can not function properly.)
•
Telnet
•
Auto-IP
•
DHCP
•
BOOTP
•
Remote Config (used by AXIS NetPilot)
•
SNMP Configuration (also used by AXIS ThinWizard. Note that if SNMP
is disabled, AXIS ThinWizard can not function properly.)
To disable these protocols, go to Admin | Security Settings | Protocol
Settings | Detailed View and mark the check boxes. Click OK to finish.
Only enabled protocols will be visible from this view!
To enable these protocols, select Admin | Network Settings | Detailed
View | TCP/IP Network for FTP, Telnet, Auto-IP, DHCP and BOOTP.
Remote Config is enabled via Admin | General Settings | RConfig
Support.
To ensure maximum security, it is highly recommended that you change your Administrator
password after generating a certificate and disabling insecure protocols! This is done from
Admin | General Settings | Change => | General | Root Password.
To check SSL/TLS status, open the print server's Web interface and select
Admin | Network Settings | Detailed View | TCP/IP Network to see if
the HTTPS Enabled parameter is set to Yes or No.
To view a Certificate, open the print server's Web interface, select Admin
| Security Settings and click View next to the Certificate.
To delete a Certificate, open the print server's Web interface, select Admin
| Security Settings and click Delete next to the Certificate.
Some USB printers do not deliver correct port status to the print server
(for instance always reporting printer off-line even if the printer is on-
line). If you set the Override Portstatus parameter to Yes, the print server
will ignore the port status. To set this parameter, select Admin | General
Settings | USB1 from the print server's Web interface.
Configuration Possibilities
121