Changing The Signal Source; Changing The Signal Type - RCA Scenium HD65W20 User Manual

Directv high-definition television user's guide hd65w20

Hide thumbs Also See for Scenium HD65W20:

Table of Contents

System Options and Preferences

Changing the Signal Source

The Signal Source menu allows you to choose the source from which you would like the

signal to come: Antenna A, Antenna B, DIRECTV, or Video Inputs. The same can be

accomplished using the ANTENNA, DIRECTV, and INPUT buttons on your remote control.

If you misplace your remote control, use the front panel buttons to access this menu and

change the signal source.

To access the Signal Source menu:

1. Press MENU on the remote control to access the main menu.

2. Select System Options from the main menu.

3. Select Signal Source from the next menu.

Select the appropriate signal source.

4. Use the arrows and OK to select which source from which you would like to receive a

signal.

The Signal Type menu lets you choose whether you are receiving a signal from cable TV

or an off-air antenna. When you run Channel Search (see "Channel Search" in this section

for details), the TV automatically detects your signal and you don't have to specify it here.

However, if you decide to change the source, you will need to use the Signal Type menu.

Note that when your signal source is coming from DIRECTV, this menu will not be

available.

Select whether you are receiving signals from an off-air antenna or cable.

Note that viewing a VCR

while in AIR mode may

result in poor picture

performance. If you have

a VCR connected to

Antenna A or Antenna B,

set the Signal Type to

Cable for that Antenna.

Chapter 7

Table of Contents