Table of Contents
Advertisement
CHANGING
THE SIGNAL
SOURCE
The Signal Source menu allows you to choose the source from which you
would like the signal to come: Antenna
A, Antenna
B, DIRECTV, or Video
Inputs. The same can be accomplished
using the ANTENNA, DIRECTV,
and INPUT buttons on your remote control.
If you misplace your remote
control,
use the front
panel buttons
to access this menu and change the
signal source.
To access the Signal Source menu:
1.
Press MENU on the remote control to access the main menu.
2.
Select System Options from the main menu.
3.
Select SignaI Source from the next menu.
Select the appropriate
signal source.
4.
Use the arrows and OK to select which source from which you
would like to receive a signal.
CHANGING
THE SIGNAL
TYPE
The Signal Type menu lets you choose whether
you are receiving a signal
from cable TV or an off-air
antenna. When you run Channel Search (see
"Channel Search" in this section for details), the TV automatically
detects your signal and you don't
have to specify it here. However, if you
decide to change the source, you will need to use the Signal Type menu.
Note that when your signal source is coming from DIRECTV, this menu
will not be available.
I Note that viewing a VCR while in AIR
|
mode may result in poor picture
J
performance. If you have a VCR connected
to Antenna A or Antenna B, set the Signal
Type to Cable for that Antenna.
Select whether you are receiving
signals from an off-air
antenna
or cable.
64
Advertisement
Table of Contents
