Table of Contents
Advertisement
Adjusting TV Controls
Audio Controls
The Audio menu lets you adjust the controls that involve the TV's audio outputs. To access
the Audio menu, press MENU on the remote, then select Audio from the main menu.
Mute
Turn Mute on (select Sound Off) to set the TV's volume to its minimum level. The same
can be accomplished by pressing MUTE on the remote control.
Tone Controls
Lets you adjust the Bass, Treble and Balance. Use the right and left arrow buttons on your
remote to adjust the sliders. Increasing the bass and treble output from the TV's internal
speakers increases the low and high tones, respectively. Adjusting the balance shifts the
audio output between the left and right internal speakers.
Audio Processor
Displays a choice list of available audio modes, which control the way the sound comes
through your speakers.
To make settings:
1. Press MENU to access the main menu.
2. Select Audio, and then select Audio Processor. Depending on your speaker setup, any
combination of the following options will appear:
•
Mono Plays the sound in monophonic audio only. This should only be used
when receiving broadcasts where distance from the broadcasters makes the stereo
signal weak. The channel banner displays the word Mono when you tune to a
program that is broadcast in mono.
•
Stereo Splits the incoming stereo audio signal into left and right front channels.
Most TV programs and recorded materials have stereo audio. The channel banner
displays the word Stereo when you tune to a program that is broadcast in stereo.
•
*SRS Stereo (•) Is an audio processing technology that adds greater depth and
stereo separation to stereo audio signals.
•
*SRS Focus (•) Focuses audio signals by adding treble and making dialog more
understandable.
48
For information on
connecting external
speakers to your HDTV,
see the section "Setup
and Connections."
Chapter 5
Advertisement
Table of Contents
