Table of Contents
Advertisement
Basic TV Operation
Using the INPUT Button
1. Repeatedly press the INPUT button to scroll through the available input sources
until you find the input associated with the component (such as VCR or DVD
player) you want to view.
Input
source
Watch the channel banner to see the input sources change with each press of
the INPUT button.
2. Once you have found the input source you want, stop pressing INPUT.
•
If you tune to VID1 and your VCR is connected to that input, you will be able to
view your VCR. To play, stop, or rewind the VCR1 tape using the remote that came
with your TV, you must first press the VCR1 button to put the remote control in VCR
mode.
There are other ways of selecting an input channel:
•
Program the component (VCR, DVD, etc.) buttons on the remote control to
automatically tune to the correct input channel when pressed. See the section in this
book, "System Options and Preferences" for information on auto tuning.
•
After pressing INPUT on the remote, enter the digits 1, 2, 3, 4, or 5 to tune to (S)VID1, 2,
3, FRONT, or CMPNT, respectively.
•
After pressing INPUT on the remote, press GUIDE on the remote control to view a
guide-like list of your line inputs and corresponding channels.
32
ON • OFF
VCR1
TV
DVD
VCR2
AUX
DIRECTV
MUTE
SKIP
CH +
CH -
FETCH
GO BACK
GUIDE
INFO
OK
MENU
CLEAR
1
2
3
4
5
6
8
9
7
INPUT
INPUT
ANTENNA
0
button
REVERSE
PLAY
FORWARD
RECORD
STOP
PAUSE
PIP
SWAP
WHO
CH CTRL
Chapter 3
Advertisement
Table of Contents
