PDG-DHT8000L Expand Serial Command Functional Specifications
8.9.41 CF_FANSPEED Command
Command
"CF_FANSPEED_%1" [CR]
"MAX" ---------------------------- Select Maximum speed of Fan Control
%1
"NOR" ---------------------------- Select Normal speed of Fan Control
Switch Fan Control Speed. (Valid only when in the normal Power ON status.)
Details
The status set by this command is stored in EEPROM and the setting remains
effective after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
8.9.42 CF_RCODE Command
Command
"CF_RCODE_%1" [CR]
"001" ------------------------------------ Select Code 1
"002" ------------------------------------ Select Code 2
"003" ------------------------------------ Select Code 3
"004" ------------------------------------ Select Code 4
"005" ------------------------------------ Select Code 5
%1
"006" ------------------------------------ Select Code 6
"007" ------------------------------------ Select Code 7
"008" ------------------------------------ Select Code 8
"UP" ---------- Switch forward (Code1→Code2→Code3 - - - →Code8→Code1)
"DN" --------- Switch backward (Code8→Code7→Code6 - - -→Code1→Code8)
Select Remote Control Code (Valid only when in the normal Power ON status)
Details
The status set by this command is stored in EEPROM and the setting remains
effective after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
8.9.43 CF_RSENS Command
Command
"CF_RSENS_%1" [CR]
"ALL" -------------------------- Select all receiver of projector
"FRONTTOP" ---------------- Select both front and top receiver of projector
"BACKTOP" ------------------ Select both back and top receiver of projector
"FRONTBACK" -------------- Select both front and back receiver of projector
"FRONT" ---------------------- Select only front receiver of projector
%1
"TOP" -------------------------- Select only top receiver of projector
"BACK" ------------------------ Select only back receiver of projector
"UP" ---------------- Switch forward (ALL → FRONTTOP→BACKTOP→
"DN" ---------------- Switch backward (BACK →TOP→FRONT→FRONTBACK→
Select location of infrared remote receiver of remote control (Available only in the
normal Power ON status)
Details
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
FRONTBACK→ FRONT →TOP → BACK→ALL)
BACKTOP →FRONTTOP→ ALL→BACK)
"000" [CR]
"Error Code" [CR]
50/101