Problem
Page breaks in unexpected
places.
Job prints from the wrong
source or on the wrong print
media.
Print media does not stack
neatly in the output bin.
Print Quality Problems
NOTE:
In this section, some procedures use the Tool Box or the Status Monitor.
For more information about Tool Box, see "Understanding the Tool Box Menus" on
page 87.
For more information about Status Monitor, see "Printer Status Window" on
page 103.
The output is too light
Action
1
The toner cartridges may be low or need to be
replaced. Confirm the amount of toner in each
toner cartridge.
Check the toner level in the Status tab in the
1
Status Monitor.
Replace the toner cartridges as necessary.
2
Is the problem recovered?
Action
Increase the setting for Fault Time-Out in the System
Settings menu in the Tool Box.
Check the
Paper Type
Turn the print media stack over in the MPF.
in the printer driver.
Yes
No
The task is
Go to action 2.
complete.
Troubleshooting
143