Port Security Commands - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
Format
no set mld mcrtexpiretime
Mode • Global Config
• Interface Config
Default disabled
Format
set mld querier <address ipv6_address>
Mode • Global Config
Format
no set mld querier address
Mode • Global Config

Port Security Commands

This section describes the command you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by locking
allowable MAC addresses on a port. Packets with a matching source MAC address are forwarded
normally, and all other packets are discarded.
Note: To enable the SNMP trap specific to port security, see
violation" on page
port-security
This command enables port locking at the system level (Global Config) or port level (Interface
.
Config)
Default disabled
Format
port-security
Mode • Global Config
• Interface Config
Switching Commands
7-51.
v1.0, November 2010
"snmp-server enable traps
3-157