Configuring The Switch Management Cpu - NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0

Configuring the Switch Management CPU

To manage the switch via the web GUI or telnet, an IP address needs to be assigned to the switch
management CPU. Whereas there are CLI commands that can be used to do this, ezconfig
simplifies the task. The tool is applicable to all NETGEAR 7000-series managed switches, and
allows you to configure the following parameters:
1. The administrator's user password and administrator-enable password
2. Management CPU IP address and network mask
3. System name and location information
The tool is interactive and uses questions to guide you through the steps required to perform its
task. At the end of the session, it will ask you if you want to save the changed information. To see
exactly what has been changed by ezconfig at the end of the session, use the show running-config
command.
To perform any switch configuration other than the items listed above, use other CLI commands or
the Web GUI.
ezconfig
This command sets the IP address, subnet mask and gateway of the device. The IP address and the
gateway must be on the same subnet.
Format
ezconfig
Mode Privileged EXEC
Management Commands
v1.0, November 2010
7-2