NETGEAR XSM7224S - ProSafe 10 Gigabit Stackable Manual page 134

ProSafe XSM7224S Managed Stackable Switch CLI Manual, Software Version 9.0
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an interface and
disables multicast storm recovery.
Format
no storm-control unicast rate
Mode Global Config
storm-control flowcontrol
This command enables 802.3x flow control for the switch and only applies to full-duplex mode
ports.
Note: 802.3x flow control works by pausing a port when the port becomes
oversubscribed and dropping all traffic for small bursts of time during the
congestion condition. This can lead to high-priority and/or network control traffic
loss.
Default disabled
Format
storm-control flowcontrol
Mode Global Config
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
no storm-control flowcontrol
Mode Global Config
Switching Commands
v1.0, November 2010
3-93