Table of Contents
Advertisement
Juniper Networks Intrusion Detection and Prevention Release Notes
Upgrading with the CLI
10
NOTE: Updating the IDP detector engine on a device does not require a
reboot of the device.
Push a security policy update job to update attack objects in use in your security policy:
4.
In NSM, select Devices > Configuration > Update Device Config.
a.
Select devices to which to push the updates and set update job options.
b.
Click OK.
c.
This section describes a workflow where you use the CLI to upgrade the software image
on the IDP Series device. You still use NSM to update the detector engine and attack
objects.
To upgrade IDP OS from the CLI:
Download the software image to a host that runs an FTP server. Follow these steps:
1.
Go to
https://www.juniper.net/customers/csc/software/
a.
customer username and password.
Enter the IDP Series device serial number to display a view of applicable software
b.
releases available for download.
Click the applicable link to display the software download page.
c.
Save the sensor_version.sh file (where version is the number that identifies the
d.
software release version).
Connect to the IDP command-line interface in one of the following ways:
2.
Use SSH to connect to the IP address or hostname for the management interface.
Log in as
admin
and enter
If you prefer, make a connection through the serial port and log in as root.
NOTE: To make an SSH connection, you must have enabled SSH for the
management port (eth0). For details, see the ACM online Help.
Use SCP or FTP to copy the software image file to the IDP appliance. The IDP appliance
3.
does not run an FTP server, so you have to initiate the FTP session from the IDP
appliance.
Run the upgrade script by entering
4.
that identifies the OS release version. When the script has finished, enter
su -
to switch to root.
sh sensor_version.sh
Copyright © 2011, Juniper Networks, Inc.
and log in with your
, where version is the number
.
reboot
Advertisement
Table of Contents
