Table of Contents
Advertisement
Next Steps:
Copyright © 2011, Juniper Networks, Inc.
In the Select Devices list, select the IDP Series devices on which to install the software
4.
update.
Click Next and complete the wizard steps.
5.
Select Automate ADM Transformation to automatically update the Abstract Data
6.
Model (ADM) for the device after NSM installs the update.
NOTE: If you clear this setting, the update is installed onto the device, but
you cannot manage the device from NSM until the device ADM is updated.
Click Finish to display upgrade status in the Job Information dialog box.
7.
When the upgrade finishes, click Close to exit the Job Information dialog box.
8.
The software upgrade is complete.
NOTE: You might encounter unexpected behavior if you have changed the
factory BIOS settings for the IDP Series device. We advise that you do not
change the factory BIOS settings.
The console will hang at GRUB after reboot if you have changed the BIOS
setting
Console redirection > Continue Console redirection after POST
To resolve this issue, press the Delete key to enter BIOS and set this option
to
OFF
.
If you are upgrading from IDP OS Release 5.0r1 or 5.0r2, skip this step. You completed
1.
it when you upgraded to IDP 5.0r1. If you are upgrading from IDP OS 4.1r4:
Run through the ACM wizard to
a.
5.0 and later, you use ACM to configure deployment mode per virtual router.
If necessary, copy any custom settings from the backup copy of user_funcs to the
b.
new user_funcs file.
Check to see if J-Security Center has released an update for the detector engine or
2.
attack database:
From the NSM main menu, select Tools > View/Update NSM attack database and
complete the wizard steps.
Push the updated IDP detector engine to IDP Series devices:
3.
From the NSM main menu, select Devices > IDP Detector Engine > Load IDP Detector
Engine for ScreenOS and complete the wizard steps.
reconfigure your virtual routers
Upgrading IDP Software
to
.
ON
. In IDP OS Release
9
Advertisement
Table of Contents
