NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Hardware Installation Manual page 13

Managed Stackable Layer 3 Switches GSM7328S v2 and GSM7352S v2 Hardware Installation
Table 2-1. LED Descriptions for GSM7328S v2 (continued)
LED Description
10/100/1000M Link/ACT LED
Ports • Off: No link is established on the port.
(2 LEDs per port) • Solid green: A valid link is established on the port.
• Blinking green: The port is sending or receiving packets.
SPD LED
• Off: No link is established on the port.
• Solid yellow: A valid 10/100 Mbps link is established on the port.
• Solid green: A valid 1000 Mbps link is established on the port.
Note: If port 21–24 media is changed to SFP, the RJ-45 LEDs
change to OFF status.
SFP Ports • Off: No SFP module link is established on the port.
(1Link/ACT LED • Solid green: A valid 1000Mbps SFP module link is established on
per port) the port.
• Blinking green: Packet transmission or reception is occurring on
the port at 1000Mbps.
• Solid yellow: A valid 100Mbps SFP module link is established on
the port.
• Blinking yellow: Packet transmission or reception is occurring on
the port at 100Mbps.
Note. If port 21–24 media is changed to copper, the SFP LEDs
change to OFF status.
SFP+ Ports SPD/Link/ACT LED:
(1 Link/ACT LED • OFF: No SFP module link is established on the port.
per port) • Solid green: A valid 10Gbps SFP+ module link is established on
the port.
• Blinking green:Packet transmission or reception is occurring on
the port at 10Gbps.
Introduction
v1.0, July 2009
2-3