NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Hardware Installation Manual page 12

Managed Stackable Layer 3 Switches GSM7328S v2 and GSM7352S v2 Hardware Installation
The following table describes the LEDs on the front panel of the switch.
Table 2-1. LED Descriptions for GSM7328S v2
LED Description
ID This is the stack member ID (1–8) that the software assigns to the
switch.
Master • Green: Switch acts as a master unit in a stack of GSM7300S
series switches.
• Off: Switch acts as a slave unit in a stack of GSM7300S switches.
RPS • Solid green: The redundant power supply is connected (and using
(redundant power the power module's power).
supply) • Solid yellow: The power module power has failed or been
disconnected, but the redundant power supply is providing power
to the switch.
• Blinking yellow: The redundant power supply unit is present, but
the power has failed.
• Off: The redundant power supply is disconnected or not present.
Fan • Solid green: Fan operating normally.
• Solid yellow: Fan has failed
• Off: No fan detected.
PWR (power) • Solid green: Power module is present and supplys power to the
switch and is working normally.
• Solid yellow: System is in boot-up stage.
• Blinking yellow: POS/CPU system has failed.
• Off: Power is disconnected.
M1, M2 XFP Module present or Stacking Adapter present and ACT LED:
High-Speed I/O XFP Module present LED /ACT
Modules • Off: The 10GbE Adapter is not present or present but link down
(1 LED per with system.
module) • Solid green: The 10GbE Adapter is present and link up with
system.
• Blinking green: Packets transmission or reception is occurring on
the port
Stacking Adapter Link/ACT LED
• Off: Stacking module is not present .
• Solid green: Stacking module is present and link up with system.
• Blinking green: Packets transmission or reception is occurring on
the port .
2-2
v1.0, July 2009
Introduction