Controller Numbering; Configure - Cisco AS5350 - Universal Access Server Configuration Manual

Configuring ISDN PRI
Table 3-2
Attribute
Channels
Trunk selection sequence
B + D glare
Directory numbers
SPIDs required?

Controller Numbering

The CT1/E1 controller numbering convention is dfc-slot/port in CLI commands. Trunk-card slot
numbering starts from the motherboard and works up from left to right. Slot 0 is reserved for the
motherboard. CT1/E1 trunk-card slots are numbered sequentially from 1 to 7. Port numbering is from 0
to 7.
The CT3 controller numbering convention is dfc-slot/port in CLI commands. Trunk-card slot numbering
starts from the motherboard and works up from left to right. Slot 0 is reserved for the motherboard.
Trunk-card slots are numbered sequentially from 1 to 7. Port number value is always 0.
Under the CT3, the CT1 controller numbering convention is dfc-slot/port:channel in CLI commands.
Port numbering values range from 1 to 28.

Configure

Command
Step 1
AS5400> enable
Password: password
AS5400#
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Step 3
AS5400(config)# isdn switch-type
switch-type
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
3-14
CT1 Configuration Attributes (continued)
Value
23 B + D
Either ascending order (from 1 to 23) or descending order (from 23 to 1)
Yield
Only 1 directory number assigned by service provider
None
Chapter 3 Basic Configuration Using the Command-Line Interface
Purpose
Enters enable mode. Enters the password. You are
in enable mode when the prompt changes to
or .
AS5350# AS5400#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
AS5400(config)#.
Selects a service provider switch type that
accommodates PRI. (Refer to
of supported switch type keywords.)
or
Table 3-3 for a list
OL-3418-02 B0