Analyzing The System Boot Dialog - Cisco AS5350 - Universal Access Server Configuration Manual

Verifying Basic Setup
The information herein applies to the Cisco AS5350, Cisco AS5400, and Cisco AS5400HPX universal
Note
gateways. Note that the latter requires use of Cisco IOS release 12.2(2)XB or later.
This chapter details the tasks required to verify that your basic system components are functioning
normally:
•
•
•
•

Analyzing the System Boot Dialog

The Cisco AS5350 and Cisco AS5400 have a specific boot sequence. To view the boot sequence through
a terminal session, you must have a console connection to the gateway before it powers up.
Note If you observe no messages on the console port, check that the baud rate is configured correctly. The
Cisco AS5350 and Cisco AS5400 console port can support a baud rate up to 115200.
The following boot sequence occurs. Step numbers and comments are inserted in the example to describe
the boot sequence.
Step 1 In the following segment, the gateway decompresses the system boot image, tests the NVRAM for
validity, and decompresses the Cisco IOS image.
System Bootstrap, Version 12.0(20000106:234457) [tombnyg-rommon_1_6 106],
SOFTWARE REV 1.6
Copyright (c) 1994-2000 by cisco Systems, Inc.
AS5350 platform with 131072 Kbytes of main memory
Self decompressing the image : #################################################
##################################################### [OK]
Self decompressing the image : #################################################
################################################################################
################################################################### [OK]
OL-3418-02 B0
Analyzing the System Boot Dialog, page 2-1
Checking the Initial Running Configuration, page 2-5
Investigating Memory Usage, page 2-7
Inspecting CPU Utilization, page 2-8
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
C H A P T E R
2
2-1