Interface Queue Wedge Monitor - Cisco AS5350 - Universal Access Server Configuration Manual

Universal gateway software configuration guide
Hide thumbs Also See for AS5350 - Universal Access Server:
Table of Contents

Advertisement

Chapter 5
Managing and Troubleshooting the Universal Port Card
Free Memory processor
Memory Fragmentation Processor
Free Memory I/O
Memory Fragmentation I/O
DFC's:
Slot 1 (NP108 DFC)
Slot 2 (NP108 DFC)
Slot 3 (NP108 DFC)
Slot 4 (NP60 DFC)
Slot 5 (NP108 DFC)
Slot 7 (CT3 DFC)

Interface Queue Wedge Monitor

The Interface Queue Wedge Monitor displays information about interface queue wedges and the times
that they occur. An interface queue is wedged when the packet count that is being transmitted (output
queue) or received (input queue) is equal to or greater than the maximum packet count size of the queue,
and consequently, no more packets are being transmitted or received.
The Interface Queue Wedge Monitor is enabled or disabled using following commands.
The Interface Queue Wedge Monitor is disabled by default.
When the Interface Queue Wedge Monitor is enabled, it monitors all the input and output queue wedge
interfaces. The show wedged-interfaces [output/input] command displays the queue wedged
interfaces.
The show wedged-interfaces output command displays the output queue wedge interfaces and their
respective time-since-wedges.
The show wedged-interfaces input command displays the input queue wedge interfaces and their
respective time-since-wedges.
Interface Queue Wedge Output Procedure
When the Interface Queue Wedge Monitor is enabled, and an interface (such as a FastEthernet0/0 output
queue is already wedged, the following message is displayed on the console, syslog, and buffer:
Eg:
The following procedure shows an example of how to enable, disable, and show the results of a wedged
interface output:
Step 1
Enable the Interface Queue Wedge Monitor.
AS5400##conf t
Enter configuration commands, one per line.
AS5400#(config)#interface-monitor enable
AS5400#(config)#^Z
AS5400##
Step 2
Show interfaces. (In this case, some interfaces are already wedged.)
AS5400##sh wedged-interfaces output
Interface Name
Async4/00
OL-3418-02 B0
interface-monitor enable
[no] interface-monitor enable
00:39:15: %HHM-3-INTFWEDGE: FastEthernet0/0 Output Queue Wedged
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
End with CNTL/Z.
Time Since Wedge
00:23:33
Interface Queue Wedge Monitor
5-23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

As5400

Table of Contents