Voip Basics - Cisco AS5350 - Universal Access Server Configuration Manual

Universal gateway software configuration guide
Hide thumbs Also See for AS5350 - Universal Access Server:
Table of Contents

Advertisement

VoIP Basics

Contents are as follows:
It is critical that you consult the additional references sited throughout and at the end of the chapter
Tip
before you configure VoIP. These plus additional references throughout the Cisco website (search for
configure voip to locate the most current references) provide the information that you need to optimize
settings. The more information that you have at your disposal, the greater your probability of success,
as measured by cost savings and user acceptance.
Although VoIP technology is primarily software-based, it requires that you install a universal port card
Note
into the appropriate slot of your Cisco AS5350 or Cisco AS5400 universal gateway. The number of ports
or channels available for sending VoIP data depends on the capacity of your card. For more information,
see
VoIP Basics
Before you configure VoIP on your gateway, it might help to understand at a high level what happens
when you place a VoIP call. Think of each event in a call flow as occurring on one of the several "legs"
of a call, as shown in the following typical scenario. Other scenarios are possible, of course, including
ones where the call destination is an IP phone and the call never leaves the IP network.
Figure 6-1
Source
Legs connecting a local device (typically a phone, fax machine, or PBX) to a gateway are called POTS
(plain old telephone service) legs. Legs connecting a gateway to the IP network are called VoIP legs. A
POTS or VoIP leg is either inbound or outbound, from the perspective of the associated gateway.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
6-2
VoIP Basics, page 6-2
Configuring Basic VoIP, page 6-6
Voice QoS Basics, page 6-15
Enabling QoS Features for VoIP, page 6-16
Additional Resources, page 6-23
Chapter 5, "Managing and Troubleshooting the Universal Port Card."
Call-leg 1: Originating device to originating gateway
Call-leg 2: Originating gateway into the IP network
Call-leg 3: IP network to destination gateway
Call-leg 4: Destination gateway to destination device
Call Legs
V
Call leg 1
(POTS dial peer)
(VoIP dial peer)
IP network
Call leg 2
Call leg 3
(VoIP dial peer)
Chapter 6
Configuring Voice over IP
Destination
V
Call leg 4
(POTS dial peer)
OL-3418-02 B0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

As5400

Table of Contents