Cisco AS5350 - Universal Access Server Configuration Manual page 102

Managing SPE Performance Statistics
•
•
show spe Commands
•
•
•
•
show port Commands
•
•
•
•
•
•
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
5-4
show spe modem {high | low} speed—Shows the connect-speeds negotiated within each high/low
speed modulation or codecs for a specific range of SPEs or all the SPEs.
show spe modem slot | slot/spe summary—Displays the history statistics of all SPEs in a particular
slot, specified SPE, or specified SPE range. It is used in the same way the show modem command
is used for MICA modems. (The show modem command is not supported on the Cisco AS5350 or
Cisco AS5400.)
show spe log—Displays the oldest event first from the slot history event log.
show spe log reverse—Displays the latest event first from the log.
show spe version—List all SPEs and the SPE firmware files used. This helps you decide if you need
to update your SPE firmware files. It is used in the same way the show modem mapping command
is used for MICA modems. (The show modem mapping command is not supported on the
Cisco AS5350 or Cisco AS5400.)
show spe fax active command displays the active statistics of all SPEs, a specified SPE, or a
specified SPE range serving fax-relay traffic.
show port config—Displays the configuration information for specified ports or the specified port
range. The port should have an active session associated at the time the command is executed.
show port [digital | modem | voice | fax] log—Displays the event log with oldest event first. For
modems, this command is used the same way the show modem log command is used for MICA
modems. (The show modem log command is not supported on the Cisco AS5350 or Cisco AS5400.)
show port [digital | modem | voice | fax] log reverse—Displays the latest event first from the port
history event log.
show port modem calltracker—Displays the port level information for an active modem call using
the calltracker database. If there is no call on the specified port, the information of the most recent
call is displayed. The call tracker feature must be enabled by invoking the calltracker enable
command. (For detailed information about the call tracker feature, see Call Tracker plus ISDN and
AAA Enhancements for the Cisco AS5300 and Cisco AS5800, available online at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121limit/121x/
121xh/121xh_2/dt_cltrk.htm)
show port modem test—Displays the test log for the specified SPE port range or all the SPE ports.
show port operational-status—Displays the operational status of the specified ports or the
specified port range. The port should have an active session associated at the time the command is
executed.
Chapter 5 Managing and Troubleshooting the Universal Port Card
OL-3418-02 B0