Configuring The Isdn Gw Mse 8321; Step One: Log In To The Web Interface; Step Two: Allocate Port Licences; Step Three: Set Up The Isdn Interface - Cisco TelePresence ISDN GW MSE 8321 Getting Started Manual

Configuring the

Step one: Log in to the web interface

1 Log in to the Supervisor web interface first.
2 Go to
Hardware > Blades
3 Log in to the ISDN GW MSE 8321 web interface:
i Type
admin
ii Click
OK
The
Login information page
We recommend that you change the admin account to use a password as
i
soon as possible. Click
page, or go to

Step two: Allocate port licences

Port licenses must be allocated to the ISDN GW MSE 8321 from the Cisco
TelePresence Supervisor MSE 8050 (Supervisor). To do this, go to the
page in the Supervisor web interface. For assistance see the Supervisor online help
topic "Allocating port licenses to blades".

Step three: Set up the ISDN interface

To define the ISDN interface type for the ISDN GW MSE 8321, go to
in the ISDN GW MSE 8321 web interface. For assistance click the help button
ISDN
for the page. Leave the advanced settings unchanged unless you have specific
configuration requirements.

Step four: Configure the ISDN ports

To configure the ISDN ports on the ISDN GW MSE 8321, go to
and specify the appropriate values for each port. For assistance click the help
ports
button for the page.

Step five: Configure call control

To define a SIP proxy for call control/address resolution, go to
use an H.323 gatekeeper, go to
help button for the page.
ISDN GW MSE 8321
and click the IP address of the ISDN GW MSE 8321.
in the username field and leave the password field blank.
.
Change password
and click the
Users
Settings > H.323

Configuring the ISDN GW MSE 8321

for the ISDN GW MSE 8321 is displayed.
on the
user ID.
admin
instead. For assistance click the
Login information
Port licenses
Settings >
Settings > ISDN
. If you
Settings > SIP
11