Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 226

Removing and Replacing the Power Supply
Using the cable tie provided, place the cable tie through the slot at the top of the right terminal block
f.
cover and secure the wiring to the left terminal block.
g. Secure outer block cover.
Wire for 4000 W (right side of power supply bay) as follows:
Step 11
Place both plastic insulators over the terminal areas, aligning the circular holes in insulating cover
a.
with terminal posts. The protective end flap on the plastic cover is opposite the wire entry area. The
protective end flap must fold down and cover the open side of the terminal (opposite side from wire
entry).
Wrap the large perforated flaps around each pair of conductors, inserting each locking tab into rear
b.
of slot. Pull the tab until the cover is secured around the power cabling trim and discard excess tab
plastic.
From the right side of the power supply, connect the ground wire to the ground
c.
Figure 5-95
Terminal
block cover
( ) Ground
Power
switch
From the right side of the power supply, connect the DC-input wires to the right power supply
d.
terminal block
From the right side of the power supply, connect the DC-input wires to TB1
e.
Figure
Cisco 7600 Series Router Installation Guide
5-98
DC-Input Wire Connections for 4000-W DC-Input Power Supply, Right Side of Power
Power leads
attached to
terminal block
(+) Positive
( - ) Negative
(+) Positive
( - ) Negative
Plastic
insulator
I
0
INP UT OK
1
Captive
installation
screw
Bay
(Figure 5-91 and
Negative (-)
Positive (+)
5-95) in this order:
Negative (-)
Positive (+)
Chapter 5
Plastic
Terminal
insulator
block cover
FAN
OUT PUT
2
3
OK
FAIL
( ) Ground
Figure 5-95) in this order:
Removal and Replacement Procedures
(Figure
Power leads
attached to
terminal block
(+) Positive
( - ) Negative
(Figure 5-91
5-95).
and
OL-4503-26