Qos Dscp Enable - TP-Link TL-SG2216 Cli Reference Manual

divide packets into 8 priorities. When IEEE 802.1P Priority is enabled, the
packets with IEEE 802.1Q tag are mapped to different priority levels based on
IEEE 802.1P priority mode. The untagged packets are mapped based on port
priority mode.
Syntax
qos dot1p config {tag} {pri}
no qos dot1p config
Parameter
tag —— The 8 priority levels defined by IEEE 802.1P, ranging from 0 to 7.
pri —— The priority level the packets with tag are mapped to. It ranges from 0
to 3, which represent TC0, TC1, TC2, TC3 respectively.
Command Mode
Global Configuration Mode
User Guidelines
1.
2.
Example
Map tag value 0 to TC3:
TP-LINK(config)# qos dot1p config 0 3

qos dscp enable

Description
The qos dscp enable command is used to enable the mapping relation
between DSCP Priority and Egress Queue. To disable the mapping relation,
please use no qos dscp enable command.
Syntax
qos dscp enable
no qos dscp enable
Command Mode
Global Configuration Mode
Example
Enable the mapping relation between DSCP Priority and Egress Queue:
By default, the mapping relation between tag and the egress queue is:
0-TC1, 1-TC0, 2-TC0, 3-TC1, 4-TC2, 5-TC2, 6-TC3, 7-TC3
Among the priority levels TC0-TC3, the bigger value, the higher
priority.
63