Using The Programmable Digital Controller; Filter Cycle Start Time; Filter Cycle Duration; Number Of Filter Cycles - Dimension One Spas @home Dream HP Owner's Manual

Using the Programmable Digital Controller

To initiate the programming sequence at any time, push and hold the PROGRAM pad for 3 seconds. If, within 10
seconds, you do not proceed with the hot tub programming, the hot tub will automatically exit the programming
sequence and revert to the pre-set factory default settings. To exit the programming sequence at any time, do not
press any pad for 10 seconds. Any programming changes made up to that point will be saved.

Filter Cycle Start Time

To adjust the filter cycle start time, push the UP or DOWN pads and LIGHT pad as done in the Clock Set
programming mode to choose a time. Once the desired time is displayed, push the PROGRAM pad to accept the
selection and move into the Filter Cycle Duration programming mode.
You will be prompted later to set the filter cycle duration and the number of filter cycles. Be sure
to keep this in mind when programming your filter cycle start time. During the filter cycle, JET 1
will activate at high speed the first 5 minutes and the remainder of the filter cycle time at low
speed.

Filter Cycle Duration

To adjust the filter cycle duration, push the UP or DOWN pads to cycle through the choices of 60, 90, 120, 150 or
180 minutes (the default is 60). Once the desired time is displayed, push the PROGRAM pad to accept the selection
and move into the Number of Filter Cycles programming mode.
Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot
climates.

Number of Filter Cycles

To adjust the number of filter cycles per day, push the UP or DOWN pads to cycle through the number of filter cycles
- 1, 2, 3 or 4 (the default is 2). Once the desired number of cycles is displayed, push the PROGRAM pad to accept the
selection and move into the Temperature Unit Selection programming mode.

Temperature Unit Selection

To select temperature units push the UP or DOWN pads to toggle between ° F (degrees Fahrenheit) or ° C (degrees
Celsius). Once the desired temperature unit is selected push the PROGRAM pad to exit the programming mode.

Initial Startup

1. Locate the Top Side Control. Directly below this
control is the equipment compartment.
2. Use screwdriver to remove the spa panel screws.
The number of screws to be
removed will depend on the
make and model of spa.
12
2002 @ Home Hot Tubs
Owner's Manual