Programmable Digital Control Messages - Dimension One Spas 2000 Model Owner's Manual

NUMBER OF FILTER CYCLES
To adjust the number of filter cycles per day, push the UP or DOWN pad
to cycle through the number of filter cycles - 1, 2, 3 or 4 (the default is
2). Once the desired number of cycles is displayed, push the PRO-
GRAM pad to accept the selection and move into the Temperature Unit
Selection programming mode..
TEMPERATURE UNIT SELECTION
To select temperature units push the UP or DOWN pads to toggle
between ˚F (degrees Fahrenheit) or ˚C (degrees Celsius). Once the
desired temperature unit is selected push the PROGRAM pad to exit the
programming mode.
NOTE: The time of day can be viewed by pushing the Dimension One
Spas icon (logo) pad on the far right of the control. If no pad is pushed
within 5 seconds, the display will revert to the spa water temperature
reading.
NOTE: All programming will revert to the factory defaults when power
to the spa is shut off and the LCD on the control will flash until a pad is
pressed.

PROGRAMMABLE DIGITAL CONTROL MESSAGES

"OH" - OVERHEAT PROTECTION
When "OH" is displayed on the control system digital display, the spa is
in a high limit condition. If such a condition exists, DO NOT ENTER
THE W ATER . If this happens, remove the spa cover and allow the
water to cool below 110˚ F, then the system will automatically reset. If
the problem recurs, turn off all power to the spa and contact your local
Authorized Dimension One Spas Dealer, or authorized service center.
"FL"- LOW FLOW
When "FL" is displayed, check the following:
1) Check the water level. If the water level is too low, fill the spa to
one to two inches above the bottom of the tile line.
2) Check to see if your filter is clean. Please see the 'Care For Your Spa'
section later in this manual for instructions.
2000 Owner's Manual
22