Table of Contents
Advertisement
assembly and the access lid or cover. After cleaning, run the pump for a
few minutes at high speed, then return to the heating mode.
To clean the Ultra Pure filter cartridge for those spas with Ultra Pure,
remove the acces lid and remove the E-Z Lock Filter cartridge by twist-
ing the cartridge 1/4 turn counterclockwise to its stop. Then lift the filter
out of its canister.. Clean the cartridge with a high pressure garden hose.
Every other cleaning, soak the cartridge in Dimension One Spas
Cartridge Cleaner, then rinse it thoroughly, and reinstall. Replace the
access lid or cover.
LIGHT BULB REPLACEMENT
All spas are equipped with a 12 volt light using a GE912 bulb. To
change the bulb, turn the power off and drain the spa below the level of
the spa light. Using the special tool provided in the owner's manual
packet, unscrew the cover for the light housing. Remove the old bulb
and install the new bulb. Screw the cover for the light housing back
into the female receptacle. Check to ensure proper operation of the new
bulb before refilling the spa.
NOTE:
1) Do not attempt to remove the light housing cover without the special
tool. If you are not able to locate it, contact the Dimension One
Spas Service Department to have one sent.
2) Be sure the O-ring is not damaged and is properly in place when
replacing the lens. Contact Dimension One Spas if a replacement
O-ring is needed.
CARE FOR THE SPA SURFACE - ULTRALIFE
Your UltraLife spa has a very high quality finish. Stains and dirt will
generally not adhere to the surface. Cleaning of the surface should be
done with baking soda or Soft Scrub. Be careful when using detergents
not to leave soap residue on the spa shell as this will cause suds build up
in the spa water and you'll find yourself changing the water more fre-
quently than should be necessary.
CARE FOR THE SPA SURFACE - QUARITE PLUS
Your Quarite Plus spa has a very high quality finish. Stains and dirt will
generally not adhere to the surface. Cleaning of the Quarite Plus surface
should be done with an acrylic surface cleaning solution. Your local
2000 Owner's Manual
42
Hide quick links:
Advertisement
Table of Contents
