Programmable Digital Control Messages - Dimension One Spas 1998 Owner's Manual

22
1998 Owner's Manual
NOTE: If you do not set the proper time, the system will default to 11:59
a.m. upon startup.
FILTER CYCLE START TIME
To adjust the filter cycle start time, push the UP or DOWN pad as done
in the Clock Set Time programming mode to choose a time. Once the
desired time is displayed, push the PUMP pad to accept the selection and
move into the Filter Cycle Duration programming mode.
FILTER CYCLE DURATION
To adjust the filter cycle duration, push the UP or DOWN pad to cycle
through the choices of 60, 90, 120, 150 or 180 minutes (the default is
60). Once the desired time is displayed, push the PUMP pad to accept the
selection and move into the Number of Filter Cycles programming mode.
NUMBER OF FILTER CYCLES
To adjust the number of filter cycles per day, push the UP or DOWN pad
to cycle through the number of filter cycles - 1, 2, 3 or 4 (the default is
2). Once the desired number of cycles is displayed, push the PUMP pad
to exit the programming mode.
NOTE: The time of day can be viewed by pushing the UP pad and the
LIGHT pad in sequence within 3 seconds. If no pad is pushed within 5
seconds, the display will always revert to the spa water temperature read-
ing.
NOTE: All programming will revert to the factory defaults when power
to the spa is shut off.

PROGRAMMABLE DIGITAL CONTROL MESSAGES

"OH" - OVERHEAT PROTECTION
When "OH" is displayed on the control system digital display, the spa is
in a high limit condition. If such a condition exists, DO NOT ENTER
THE WATER. If this happens, remove the spa cover and allow the water
to cool below 106˚ F, then push any pad on the upper control and the sys-
tem will reset. If the problem recurs, turn off all power to the spa and
contact your local Authorized Dimension One Spas Dealer, or authorized
service center.