Ready (Check Saddle Stitch Stapler) - Oki CX1145 MFP Operator's Manual For Basic Function

6. "READY (CHECK SADDLE STITCH STAPLER)"

This message will be shown only when the Saddle Stitch Finisher (optional) is installed. It appears when
the staples in the stapler of the Saddle Stitch Finisher run out or when the staples in the Saddle Stitch Fin-
isher are jammed.
Remove the jammed staples according to the procedure in ! P.304 "5."Examine stapler in the Saddle
Stitch Unit"".
If the staples run out, follow the procedure below as well as the procedure in ! P.297 "2."Check staple
cartridge in the Saddle Stitch Unit"".
Follow steps 1 to 6 of ! P.297 "2."Check staple cartridge in the Sad-
1
dle Stitch Unit"".
• Do not close the front cover of the Saddle Stitch Finisher.
2 Check the following 2 items to perform test stapling.
• Whether the Saddle Stitch Finisher is securely installed in the equipment.
• Whether any LD or LT-R paper is set in the equipment.
3 Close the front cover of the Saddle Stitch Finisher.
• Test stapling is automatically performed.
10
If the front cover of the Saddle Stitch Finisher is closed without satisfying the condition of step 2, test stapling is
not performed. Test stapling is necessary to prevent void stapling. After satisfying the condition of step 2 and
opening/closing the front cover of the Saddle Stitch Finisher again, be sure to perform the test stapling.
307
10.WHEN THIS MESSAGE APPEARS