Oki CX1145 MFP Operator's Manual For Basic Function page 52

4 Press the [START] button.
• Copying starts. The paper exits with its copied side down.
• When the drawer runs out of paper during copying, a paper
source of the same size and direction is automatically selected
and copying continues.
• When the drawer runs out of paper during copying, the corre-
sponding drawer on the touch panel and the [JOB STATUS] but-
ton on the control panel blink. Add paper to this drawer or select
another one with the same paper size.
• Be careful because the paper exit area and paper just after exit-
ing are hot.
Placing an original on the original glass
1 Place paper in the drawer(s).
• For the types and sizes of paper selectable, see ! P.30 "Acceptable copy paper".
When the desired size or type of paper is not in any of the drawers or the Large Capacity Feeder, see the follow-
ing pages.
- ! P.32 "Setting copy paper (size change)"
- ! P.37 "Placing paper in the Large Capacity Feeder (optional)"
- ! P.58 "3.Bypass Copying"
2 Place the original(s).
• See the following pages to set the originals.
- ! P.43 "Acceptable originals"
- ! P.45 "Placing originals on the glass"
The originals are copied in the order of being scanned.
3 Select the copy modes as required. When you want to copy more than
one set, key in the desired number of copies.
• Press the [CLEAR] button on the control panel to correct the number keyed in.
• Note that some combinations of copy modes are restricted. (! P.338 "4.Copying Function Combination
Matrix", ! P.340 "5.Image Quality Adjustment Combination Matrix")
• Once the [START] button on the control panel has pressed, any change in copy modes (including setting of the
previously divided sets of originals) cannot be applied afterward.
2
52