Connecting The Cables - Oki C5510nMFP Setup And Installation Manual

CONNECTING THE CABLES

Connect the ADF cable
Connect the ADF cable (attached to the documents cover), to the
ADF port on the scan unit.
Connect The Ethernet cable
Connect one end of your Ethernet LAN cable to an available port
of your Ethernet hub. Connect the other end to the LAN port at
the back of the scan unit.
Connect the printing unit cable
Connect one end of the USB cable (short cable) to the printing
unit. Connect the other end to the Copy port of the scanning unit.
Connect the computer cable
IMPORTANT NOTE!
To ensure the scan function works properly, install the
Scanning Unit Driver before connecting the USB cable
to your computer.
Connect one end of the USB cable (long cable) to the USB port
on the scanning unit. DO NOT connect the other end to your
computer. Complete the connection only after installing the
driver.
Connect the scanning unit power adapter
1. To mount the power adapter box to the back of the scanning
unit, position the clip on the back of the box on the scanning
unit frame as shown, then slide the box to the left until it
locks in place.
2. Be sure the power switch is in the "O" position. Connect the
power adapter cable to the power port.
7