Setting Up The Printing Unit - Oki C5510nMFP Setup And Installation Manual

SETTING UP THE PRINTING UNIT

1. Remove the transport tape from front and back of printing
unit.
Do not remove the orange paper band extending from
inside the printing unit on the right side. This band
provides instructions for preparing the fusing unit.
1. Place the printing unit on the surface you have chosen. Place
the support bracket (1) near where the back of the printing
unit will be.
WARNING!
The support bracket prevents the unit from tipping over
when in use. Using the unit without installing the
support bracket may cause damage or personal injury.
2. Carefully lift the back of the printing unit and align the wells
under the back of the printing unit with the plugs on the
support bracket. Lower the printing unit on top of the
bracket. This will provide stability for the MFP when the
scanning unit is attached.
NOTE!
1
3. Make sure the printing unit and the support bracket are
aligned and firmly in place.
4. Remove the orange transport restraints from the scanning
unit mounts. To do this, first release the tape. Then, turn the
locking knob counterclockwise to release the restraint and
pull it out.
5