Initial Cli Configuration - Cisco WS-C1924-A - Catalyst 1900 24 Ports 10MB Switch Hardware Installation Manual

Chapter 5 Configuring the Router
If the system configuration dialog message does not appear, a default configuration file was installed on
the router prior to shipping. See the
page 5-6
For help with interface and port numbering, see the
This section contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
•

Initial CLI Configuration

Procedure
Step 1 When the system message appears on the router, enter no.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return to terminate autoinstall and continue with manual configuration:
Step 2
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Press Return to bring up the
Step 3
...
flashfs[4]: Initialization complete.
Router>
Type enable to enter privileged EXEC mode:
Step 4
Router> enable
OL-19084-02
to configure the router.
Initial CLI Configuration, page 5-7
Configuring the Router Hostname, page 5-8
Configuring the Enable and Enable Secret Passwords, page 5-9
Configuring the Console Idle Privileged EXEC Timeout, page 5-10
Configuring Gigabit Ethernet Interfaces, page 5-12
Specifying a Default Route or Gateway of Last Resort, page 5-14
Configuring IP Routing and IP Protocols, page 5-14
Configuring Virtual Terminal Lines for Remote Console Access, page 5-17
Configuring the Auxiliary Line, page 5-18
Verifying Network Connectivity, page 5-19
Saving Your Router Configuration, page 5-21
Saving Backup Copies of Configuration and System Image, page 5-21
Router>
Performing the Initial Configuration on the Router
"Using Cisco Configuration Professional Express" section on
"Interface Numbering" section on page
(Required)
(Optional)
(Required)
(Required)
(Optional)
(Required)
(Required)
prompt.
Cisco 1900 Series Hardware Installation
1-13.
(Required)
(Optional)
(Required)
(Required)
(Optional)
5-7