Initial Configuration Using The Cli (Manual Configuration) - Cisco 2612 Hardware Installation Manual

Configuring the Router
The configuration is displayed:
Step 11
The following configuration command script was created:
hostname fig
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
Respond to the following prompts. Select [2] to save the initial configuration.:
Step 12
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
The user prompt appears:
Step 13
2600>
After you complete the initial configuration tasks, your Cisco router is ready to configure for specific
functions. For configuration procedures, refer to the
Series, Cisco 3600 Series, and Cisco 3700 Series
documentation. You can access these documents on Cisco.com and on the Documentation CD-ROM.

Initial Configuration Using the CLI (Manual Configuration)

This section shows how to bring up a command-line interface (CLI) prompt for configuration using the
CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the
following messages at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Cisco 2600 Series Routers Hardware Installation Guide
3-28
Chapter 3
Software Configuration Guide for Cisco 2600
Routers. or the Cisco IOS software configuration
Installing the Router
OL-2171-06