Cisco WS-C1924-A - Catalyst 1900 24 Ports 10MB Switch Hardware Installation Manual page 54

Setting Up the Chassis
Figure 4-4
Figure 4-4
1
Wall screws
3 Chassis mounting holes (on bottom)
5 Mounting surface
To mount the router on a wall or other surface, follow these steps:
Procedure
Step 1 Install the two screws 5 inches (12.7 centimeters) horizontally apart on a wall or other vertical surface.
The screws should protrude 0.25 inch (0.6 centimeter) from the surface of the wall.
Caution
Remove the rubber feet from the router.
Step 2
Cisco 1900 Series Hardware Installation
4-6
shows the wall-mounting features on the Cisco 1941 series routers.
Wall-Mounting Features on the Cisco 1941 Router
1
2
If you install the screws in drywall, use hollow-wall anchors (1/8 inch by 5/16 inch) to secure
the screws. If the screws are not properly anchored, the strain of the cables connected to the
router back panel could pull the router from the wall.
Chapter 4 Installing and Connecting the Router
5
4
3
2
5 inches (12.7 cm)
4 Router chassis
OL-19084-02