Cisco WS-C1924-A - Catalyst 1900 24 Ports 10MB Switch Hardware Installation Manual page 78

Performing the Initial Configuration on the Router
Procedure
Step 1 Enter the setup command facility. From the Cisco IOS CLI, enter the setup command in privileged
EXEC mode, enter the following:
Router> enable
Password: <password>
Router# setup
Continue with configuration dialog? [yes/no]:
To proceed using the setup command facility, enter yes.
Step 2
Continue with configuration dialog? [yes/no]:
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3 Proceed using basic management setup, which configures only enough connectivity:
Would you like to enter basic management setup? [yes/no]: yes
Step 4 Enter a hostname for the router:
Configuring global parameters:
Enter host name [Router]:
Enter an enable secret password. This password is encrypted (for more security) and cannot be seen
Step 5
when viewing the configuration.
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: cisco
Enter an enable password that is different from the enable secret password. This password is not
Step 6
encrypted (and is less secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: cisco123
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
Step 7
other than the console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: cisco
Respond to the following prompts as appropriate for your network:
Step 8
Configure SNMP Network Management? [no]: yes
Community string [public]:
The system displays a summary of the available interfaces.
Note
Cisco 1900 Series Hardware Installation
5-4
--- System Configuration Dialog ---
myrouter
The interface summary includes interface numbering, which depends on the router model and
the installed modules and interface cards.
Chapter 5 Configuring the Router
OL-19084-02