Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual page 72

Wizard Page
Discovered Product Filter
Select Licensed Products
to Create
Destination Folder
License Entitlements
Auto-reconcile Create
Summary
4 If you haven't done so already, click Finish to create the licensed product and add it to the
Licensed Products list.
5 If the Auto-Reconcile Wizard was unable to associate your catalog product with the licensed
product:
5a Click the licensed product.
72 ZENworks 10 Configuration Management Administration Quick Start
Details
The Auto-Reconcile Wizard creates licensed products from existing
discovered products.To find your discovered product:
1. Click the Products Specified Below option.
2. In the Select list, select the manufacturer of your discovered
product.
3. In the Product field, enter the name of your discovered product.
Based on the information you specified on the Discovered Product
Filter page, this page should display your discovered product and the
licensed that will be created for it.
The wizard attempts to match catalog products to the discovered
product by comparing the Manufacturer and Product fields. If the
wizard was able to match the catalog product you created to your
discovered product, the catalog product is listed as well. Select the
catalog product to associate it with the licensed product.
If the wizard is unable to match the catalog product to the discovered
product, you will need to manually assign the catalog product after
completing the wizard.
Select the folder where you want to place the new licensed product.
The field defaults to the current folder (the folder from which you
launched the Auto-Reconcile Wizard). To specify another folder, click
to browse for and select the folder. The folder must already exist;
you cannot use the selection dialog to create a new folder.
Every licensed product must have at least one entitlement and license
model.
An entitlement typically represents a license agreement. In many
cases, a licensed product might have only one entitlement. However,
by allowing multiple entitlements, you can determine compliance for a
licensed product that has several license agreements. For example,
you might have a full license agreement and an upgrade license
agreement for the same product. Rather than creating two separate
licensed products for the same product, you create one licensed
product with two different entitlements.
The license model determines how the licenses are counted. Licenses
can be counted per installation, user, or device.
For this scenario, specify Per-Installation as the description and select
Per-Installation as the license model. This causes each installation of
the product to consume a license.
Review your data.