Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ADMINISTRATION QUICK START 10.3 Quick Start Manual page 58

5 In the Remote Diagnostics dialog box, fill in the following fields:
Device: Specify the name or the IP address of the device you want to remotely diagnose.
Application: Select the application you want to launch on the device to remotely diagnose.
Authentication: Select the mode you want to use to authenticate to the managed device. The
two options are:
Password: Provides password-based authentication to perform a Remote Diagnostic
operation. You must enter the correct password as set by the user on the managed device
or as configured by the administrator in the security settings of the Remote Management
policy. The password set by the user takes precedence over the password configured by
the administrator.
Rights: This option is available only when you select the managed device on which you
want to perform the remote operation. If an administrator has already assigned Remote
Management rights to you to perform the desired remote operation on the selected
managed device, you automatically gain access when the session initiates.
Port: Specify the port number on which the Remote Management Agent is listening. By
default, the port number is 5950.
Session Mode: Does not apply to the Remote Diagnostics operation.
Session Encryption: Ensures that the remote session is secured by using SSL encryption
(TLSv1 protocol).
Enable Caching: Enables caching of the remote management session data to enhance
performance. This option is currently supported only on Windows.
Enable Dynamic Bandwidth Optimization: Enables detection of the available network
bandwidth and accordingly adjusts the session settings to enhance performance.
58 ZENworks 10 Configuration Management Administration Quick Start