NETGEAR DGN2200v1 Setup Manual page 8

Table 1. LED and Front Panel Button Descriptions (continued)
LED LED Activity
USB Off
Solid green
Blinking green
DSL Solid green
Blinking green
Off
Internet Port Solid green
Solid red
Blinking green
Off
Wireless Solid green
Blinking green
Off
WPS Solid green
Blinking green
Off
Button
Turn the wireless radio in the wireless-N modem router on and off. The wireless radio is on by
default. The LED located below this button indicates if the wireless radio is on or off.
Wireless
On/Off
Pushing this button opens a 2-minute window for the wireless-N modem router to connect
with other WPS-enabled devices. For more information, about using the WPS method to
implement security, see
Push 'N'
on page
Connect
(WPS)
Getting to Know Your Wireless Router
Description
• No USB device connected.
• "Safely Remove Hardware" has been activated.
• An error has occurred with the device.
USB device is ready to use.
USB device is in use.
The ADSL port is synchronized with an ISP's network-access device.
Indicates ADSL training—ADSL is synchronizing with the DSLAM.
The unit is off or there is no IP connection.
There is an Internet session. If the session is dropped due to an idle
timeout, and an ADSL connection is still present, the light will remain
green. If the session is dropped for any other reason, the light will
turn off.
IP connection failed (no DHCP or PPoE response, PPPoE
authentication failed).
Data is being transmitted over the ADSL port.
No Internet connection detected or device in bridged mode.
Indicates that the Wireless port is initialized.
Data is being transmitted or received over the wireless link.
The Wireless Access Point is turned off.
WPS wireless security is being enabled.
The device is in the 2-minute interval to synchronize security.
WPS is not being set or enabled.
"Using Push 'N' Connect (WPS) to Configure Your Wireless Network"
22.
Description
4