Default Configuration - NETGEAR DGN2200v1 Setup Manual

Default Configuration

You can use the Restore Factory Settings button located on the bottom of your router to reset all
settings to their factory defaults. This is called a hard reset. To perform a hard reset, push and hold
the Restore Factory Settings button for 6 seconds. Your router will return to the factory
configuration settings that are shown in the table below.
Feature
Router Login
User login URL
User name (case sensitive)
Login password (case sensitive)
Internet Connection
WAN MAC address
WAN MTU size
Port speed
Local Network (LAN)
LAN IP
Subnet mask
RIP direction
RIP version
RIP authentication
DHCP server
DHCP starting IP address
DHCP ending IP address
DMZ
Time zone
Time zone adjusted for daylight saving
time
Technical Specifications
Default Behavior
http://www.routerlogin.net or http://www.routerlogin.com
admin
password
Use default address
1492
AutoSense
192.168.0.1
255.255.255.0
None
Disabled
None
Enabled
192.168.0.2
192.168.0.254
Disabled
GMT-8 for NA version, GMT for WW version, GMT + 1 for
Annex B German version
Disabled
36