Table of Contents
Advertisement
Interrupt request are shared as shown the table below:
PCI slot 1
PCI slot 2
PCI slot 3
PCI slot 4
PCI slot 5
PCI slot 6
AGP slot
AC97/MC97
Onboard USB
Onboard USB 1
Onboard USB 2
IMPORTANT!
2-5-4 AGP Slot
This motherboard provides an AGP Slot, support the 4X/8X AGP VGA card.
2-6 Connectors, Headers
2-6-1 Connectors
(1)
Power Connector (20-pin block) : ATXPOW
ATX Power Supply connector. This is a new defined 20-pins connector that usually comes
with ATX case. The ATX Power Supply allows to use soft power on momentary switch that
connect from the front panel switch to 2-pins Power On jumper pole on the motherboard.
When the power switch on the back of the ATX power supply turned on, the full power will not
come into the system board until the front panel switch is momentarily pressed. Press this
switch again will turn off the power to the system board.
INT A
Shared
Shared
Shared
If using PCI cards on shared slots, make sure that the drivers support
"Shared IRQ" or that the cards don't need IRQ assignments. Conflicts will
arise between the two PCI groups that will make the system unstable or
cards inoperable.
INT B
INT C
Shared
Shared
Shared
AG P SLO T
12
INT D
Shared
Shared
Shared
Shared
Advertisement
Table of Contents
